J & M ジェーアンドエム スピーカーキット リア 20HM FLHTCU 【SPEAKER RR 20HM FLHTCU】

　・71/4”round drivers are the largest diameter speakers that can be installed into the Harley® Road Glide style fairing， with cone volume and mass comparable to a 6”x 9”speaker
・51/4”round drivers are the largest and most efficient speakers you can install into the rear speaker pod position on the Harley Road Glide Ultra
・Two-speaker kits include：2 speakers， custom-made plug-n-play wiring harness， top quality heavy gauge power/ground wires， all necessary mounting hardware， complete installation/operation instructions and 180w RMS 2-CH amplifier
・Four-speaker kits include：4 speakers， custom-made plug-n-play wiring harness， top quality heavy gauge power/ground wires， mounting hardware， installation/operation instructions and 360w RMS 4-CH amplifier
・Six-speaker kits include：6 speakers， custom-made plug-n-play wiring harness， top quality heavy gauge power/ground wires， mounting hardware， installation/operation instructions and 360w RMS amplifier
・At 2 ohms impedance and 140/120+ watts max power， these speakers provide the ultimate in bass response， extended mid/high frequency range and raw audio power
・Feature a waterproof injection-molded polycarbonate woofer cone， high-flux strength but lightweight， dual-donut Neodymium magnet， high-efficiency voice coil， the latest design grillework with mounted tweeter and mid-range and top-quality adapter rings/bracket hardware for secure and clean mounting into the Road Glide Ultra
・The most efficient speakers you can buy for your Harley， and their mounting hole pattern and spade electrical connections are exactly the same as the factory specification
・Full-range class D amplifier at 90W RMS per channel x 4 channels；360W total， driven into a 2 ohm load at 14.4 VDC
・Amplifier gain adjustments are factory preset for 2-， 4- or 6-speaker configuration on the Harley Road Glide Ultra
・Amps mount inside the fairing using the custom-made stainless steel bracket system
・Include custom-made plug-n-play wiring harnesses， all necessary mounting hardware and installation/operation instructions
・Amplifier measures 71/4”L x 43/4”W x 13/4”T

■注意点
※取り扱い説明書は英語となります。
※輸入商材の為、納期が遅れる場合がございます。あらかじめご了承ください。