Monoprice Monoprice Commercial Audio 120W 5ch 100/70V Mixer Amp with Microphone Priority (NO LOGO)

• XLR & 1/4 inch mic inputs, RCA stereo line inputs, RCA stereo line out.
• Emergency trigger all off except for Mic 1 + Mic ducking (auto attenuation of line ins when mic is in use).
• 70/100V allows numerous speakers to be connected without complicated impedance calculations.
• Plug and play configuration.
• Built-in short circuit, over-current, and high temperature protection circuits. Line level output of mixed signal for connection to other devices.

説明: Simplify the task of running distributed audio for restaurants, hotels, or anywhere large areas need background music and/or paging address systems. Connect hundreds of speakers covering acres of area without the need for large equipment racks. A constant voltage speaker system differs from a traditional 8ohm speaker system in that it uses a step-up transformer at the audio source to raise the voltage and lower the current on the transmission line. At the speaker end, a step-down transformer converts the signal back to a normal speaker level voltage. This reduces power loss during transmission, which allows for the use of longer speaker wire runs using smaller gauge wire. Additionally, a constant voltage speaker system allows for the use of multiple speakers on each channel, without the need for complicated impedance calculations and configurations. In a constant voltage system, all speakers on a given channel are connected in parallel and the complicated impedance calculations are replaced by simple wattage calculations. For example, if you want to connect two speakers per channel in a traditional 8ohm speaker system, you must either connect them in series, which results in an overall 16ohm impedance, or in parallel, which results in an overall 4ohm impedance. In the first case, the 16ohms impedance effectively halves the output power of your amplifier, resulting in lower overall volume levels. In the latter case, the 4ohms impedance means that your amplifier will have to work harder and must be rated as stable at 4ohms. Adding a third speaker to the mix would complicate it further, producing either a 24ohm or 2ohm overall impedance. Note that very few amplifiers are stable under 2-ohm loads, so that is usually not an option. On the other hand, with a constant voltage system, you consider first the RMS output wattage of the amplifier. This should be reduced by 20% to compensate for insertion loss. For example, if using a 100-watt amplifier, the total load from

全国送料無料。海外倉庫から国内に取り寄せますので、お届けまで2-3週間程度お時間頂いております。また、税関審査により、開封による外箱の損傷の可能性が稀にございますが、商品自体の品質は問題ございませんのでご安心ください。国内到着後に一度検品して発送させて頂きます。商品についてご不明な点がございましたら、「この商品について問い合わせ」ボタンからお気軽にお問い合わせください。(商品が電波法上の技術基準に適合する必要がある無線機器の場合：商品は並行輸入品でございますので、電波法上の技術基準に適合いたしません。日本国内で使用すると電波法に違反するおそれがありますのでご購入、ご使用には十分ご注意ください)

カテゴリー:
メーカー: Monoprice
ブランド: Monoprice
高さ: 53.6 センチ
幅: 47.0 センチ
奥行: 25.7 センチ
重量: 6.7 Kg